[Resuelto] Execute on Load  

  RSS

hiren.ectech
(@hiren-ectech)
Active Member
Registrado:hace 9 meses 
Respuestas: 15
07/09/2017 3:23 am  

Dear Javier,

One other point where I am stuck....

I need to execute a certain part of the circuit only once when the VM is called.

This part of the circuit should not be executed afterwards.

Can you please help me to resolve this problem? 

Thanks in advance,

Hiren


ResponderCitar
admin
(@admin)
Miembro Admin
Registrado:hace 10 meses 
Respuestas: 45
07/09/2017 10:29 pm  

 

Hi,

When you need force the flow you must use variables and flowchart elements...

In this Page (Documents Section) There is a PDF with information about Flowchart Elements.

It Document is in Spanish but you can easy translate it (and the icons will guide you because still they are equals in the distribution and the document) or you can see the flowchart english examples in the MyOpenLab Distribution to understand the elements functions.

I have attached an example.

Best regards,

Javier Velásquez


ResponderCitar
hiren.ectech
(@hiren-ectech)
Active Member
Registrado:hace 9 meses 
Respuestas: 15
08/09/2017 4:14 am  

Dear Javier,

Thanks for quick reply.

In your example, I believe that the circuit is still executing completely but by making sure that the trigger variable remains low after one execution. This is bit tricky to figure out.

We may have some better method like a pulse element that automatically triggers only once when the VM is loaded.

Still, the solution you provided holds good enough for my purpose.

Thanks a lot!!

Regards,

Hiren


ResponderCitar
  
Trabajando